Customer Ratings & Reviews

This Sanus bracket goes a few steps beyond similar, cheaper brackets with a similar appearance. The Sanus difference is that it provides flexibility and access that others do not. For example, you can extend the TV out by up to 6.8 in. so that you can reach connecting cables and the release tabs should you wish to take the set down. That same extension allows more clearance for the bottom edge of the TV so that tilt can be maximized. The two scissor extenders operate independently, so there is a bit of horizontal swivel possible, too. Extending the arms when you hang the set on the mount gives you much better visibility. A screw adjustment at the top of each arm allow about a 1/2 in. of up or down travel - reassuring in case you don't install the mount perfectly level. If it you did perfectly level the mount, those adjustments allow you to fine tune the TV height (center the adjustments on their travel before you hang the TV). After the TV is hung (mine is a 55 in. Roku Plus series, with low VESA mounting holes, mounted high for bedroom use), you can slide it back and forth horizontally as required. Once your final tilt position is made, you can hand tighten each side so the TV stays at the desired angle. The instructions provided are good, if you read them carefully, except for placing the arms on the TV. The instructions aren't clear about the vertical positioning, and this could make a difference if your set's mounting holes are located low, rather than centered on your set. After a lot of thought, I believe that Sanus wants you center the arms vertically over the TV mounting holes whether the TV mounting holes are centered or low on the TV. But if the arms will then show, they want you to mount the arms higher so that the arms do not show when the set goes on the wall. Sanus does provide a height finder tool on their website that will tell you how far above the floor you should place the bracket, and it's even aware of where the holes are on a particular TV. But it can only be correct, I think, if you center the arms vertically on the holes whether the holes are centered or low on your set. In the end, I would suggest you trust, but verify, the results given by the height finder. I found that it got within about an inch of the desired height. The most difficult part of the installation may be finding your studs. My stud finder was not working reliably, so I pushed a pin with a plastic ball on its head through the dry wall on either side of center to find the edges of the studs. Sanus provides all kinds of screws, washers, and spacers, most of which you won't use, some concrete anchors, a hex wrench to make the height/leveling adjustments, and a heavy duty template that you use to determine the four drill locations. You need to provide a level, a drill, and a socket wrench. I found that if the template is level, the bracket will be also. But if not, you've got the adjustments!

Great product. It gives us the tilt and angle we wanted and is much more flexible in terms of installation that the fully articulated option we tried first. The tilt also makes it easy to access the connections on the back of the tv. The tv is 70” and is flush to the wall - a very sleek install. It was also a lot cheaper. Note: we had this installed by the Geek Squad.

The TV mount I recently purchased, known as the "SleekView Universal TV Mount,"has proven to be a reliable and versatile addition to my home entertainment setup. Offering both functionality and aesthetics, this mount provides a secure and space-saving solution for displaying my television. First and foremost, the build quality of the SleekView TV mount is impressive. Constructed from durable materials, it instills confidence that my television is safely supported. The mount's sturdy design ensures stability, even when adjusting the viewing angle or swivelling the TV. I appreciate the peace of mind that comes with knowing my valuable screen is securely mounted on the wall. Installation of the SleekView TV mount was straightforward and hassle-free. The package included all the necessary hardware, and the clear instructions made the process relatively simple, even for someone without extensive DIY experience. Within a short time, my TV was securely attached to the wall, allowing for a clean and clutter-free setup. The mount's versatility is another notable aspect. It accommodates a wide range of television sizes and is compatible with VESA mounting patterns, offering flexibility for different models. I found it easy to adjust the tilt and swivel angles to achieve the optimal viewing position for my preferred seating arrangement. This adaptability ensures that users can enjoy their favorite shows and movies from various angles, enhancing the overall viewing experience. In terms of aesthetics, the SleekView TV mount lives up to its name. With its slim profile and minimalistic design, it seamlessly blends with my living room decor. The low-profile mount keeps the TV close to the wall, creating a sleek and modern appearance. Additionally, the ability to conceal cables within the mount's built-in cable management system further contributes to a clean and organized look.

Was hesitant to buy this because of the cost but it was worth it. Never thought I would need to move the tv to the right or left but recently rearranged the living room and was able to center the tv because of this feature. I can also tilt the tv towards the kitchen while I am cooking. Planning on buying another one for the bedroom.

It’s a great TV mount. It provides a some tilt and a little left to right angling. No where near a full movement mount, but allows a wide, sturdy mount for my 75 inch TV. The one negative is the lack of clarity in the instructions on how wide beyond a stud is acceptable without an additional wall attachment. I needed the TV centered on the wall, but with my VESA pattern and the stud position it would result in the right side of the mount unsupported for 10+ inches. I added two cross 2x4s between the studs on that side and

I recently bought this Sinus Elite bracket for my “65 LG C4 and I am very happy with my decision to purchase this. The Bracket comes with a template included for installation. It took me about 45 minutes to install my tv on the wall. As for the functionality, the bracket does as advertised. It tilts 360! Up, down, left and right.I recommend this bracket if you are looking for a sleek and smooth operating bracket.

Really easy to install, quickly allows access to connect your HDMI cables or simply bring your screen out. The instructions can be a bit confusing but the manufacturer does have a quick and simple is to install video. Plenty of hardware included, comes individually wrapped and labeled.

Best mount there is for any size TV. Easy to install! Also, gives flexibility to balance TV and ability to access ports with 4D tilt. Using it for my 77” and 85” TVs. Recommended to families and friends.

This was easy to install. One thing I will say are the sliders on back of TV mounting bracket that allows the TV to tilt could be loose from factory. Simply tighten them to correct. The spacers provided for mounting the TV on the mount are a little cheap looking but do work. I like the fact I can pivot the TV far enough from the wall to allow better access to wiring and behind tv. This mounting bracket feels very well made and solid holding the TV.

I have never mounted a tv before so I figured it would be hard. I WAS RIGHT! This thing looked easy but was a nightmare to put together!! And don't be fooled by the phone number in the box stating "we're here to help." They DID NOT answer the phone. I called numerous times. The links provided for the helpful videos also did not work for me, but it was a simple matter of entering the information into YouTube, so that wasn't an issue. Two important things I didn't know (and couldn't find the answer to) were 1) "which holes do I use to place the mount on the tv" and 2) Is it okay that my tv required two different screws to secure the mount? For question 1, I centered the mount on the back of the tv and hoped for the best. For question 2, I went ahead and used two different screws since they were the ones that fit. The package comes with all the screws that are needed so that also wasn't an issue. THE CARDBOARD CUTOUT WAS A LIFESAVER!!! My 70in tv feels very secure and looks great on the wall. If I hired a professional, I would have given this product 5 stars but since I did it myself and had issues that I had to figure out on my own, 3 stars is very generous! The automatic measurement guide that tells you where to place the tv on the wall was also a bunch of nonsense!!! I put in all of the correct information and was still given an incorrect placement option. My very common brand tv was also not included in the drop down menu so I had to use a similar brand (which I had to research based on measurements) in order to get correct options for placement. I will say that placing the tv onto the mount once everything was screwed in was very easy. If you have patience, this product is great! If not, get a professional because it's still a good product! It definitely would have been easier with a smaller tv.

Great mount, simple to install and hang the tv. Wide open back makes it very easy to add outlet and cable pass through. Well worth the premium over some of the cheaper models available. Used to hang a 77" Samsung S90D

i had the geek squad install sanus tilt tv mount with my 75” samsung TV, and I couldn’t be happier with the results. I’ve had the mount for almost 2 years now. The mount feels incredibly sturdy and secure, giving me peace of mind that my TV is safely supported. One of the standout features is the tilt functionality, which allows for easy adjustments to reduce glare and achieve the perfect viewing angle. The mount also extends slightly from the wall, making it convenient to access cables and ports behind the TV. Overall, the Sanus Tilt TV Wall Mount is a high-quality, reliable option that enhances the viewing experience. I highly recommend it to anyone looking for a durable and adjustable TV mount.

Look no further. If you have an extra large television like I do, this is the wall mount for you. The instructions are so easy to follow that anyone can do it. The Height Finder calculator located on Sanus’s website makes it a breeze to find out where to drill your holes. I will warn you though, make sure that you know where the mounting holes are on the back of your tv. If they are not centered, it will throw off the calculations and you’ll have to adjust for that. It can tilt forward, backwards, left, and right. Plus extend out about 7 inches. Overall this is the best mount that you can buy. Nothing negative to say at all.

Easy to hang. Love how it t can be tilted, moved forward and moved left to right. Comes with all the bolts and even a “level”

This is not the first Sanus TV wall Mount that I have purchased, but it represents the best one to date; Easy to install, both the portion that attaches to the TV and (more importantly) the main fram that attaches to the wall. Determining the height to place the mount at was imtuitive, all the mounting hardware was included and leveling was seamless. The only assistance required involves recruiting an assistant to help lift the 75-inch Samsung TV into place. Very pleased with this purchase and highly recommend this wall mount system from Sanus, purchased at Best Buy at a fair price.

Have this holding up my LG 77” C4 television I got from Best Buy and it’s doing what it was designed to do. I like its stability, and that I am easily able to tilt my TV to different angles. It’s also great how slim it is and that your able to adjust the TV to being super close to the wall, but you’re able to pull it out out far enough to attach wires or accessories to your tv.

The Sanus Premium Series Advanced Tilt 4D TV Wall Mount is an exceptional product that deserves a five-star rating. Designed to fit most TVs ranging from 42"-90", this wall mount can accommodate up to 150lbs of weight. The sleek black finish gives your living room a modern and sophisticated look. One of the major benefits of this wall mount is its four-way tilt feature, which allows you to adjust your TV up or down by 15 degrees and left or right by 30 degrees. This means you can easily find the perfect viewing angle to reduce glare and improve your TV watching experience. The Sanus Premium Series Advanced Tilt 4D TV Wall Mount is also incredibly easy to install. With step-by-step instructions and all the necessary hardware included, you can securely mount your TV in no time. Overall, I highly recommend the Sanus Premium Series Advanced Tilt 4D TV Wall Mount for anyone looking to enhance their home theater experience. Its durability, flexibility, and ease of installation make it an excellent investment for any homeowner.

This is a very good bracket. it pulls away from the wall enough to make all of your connections from the wall to the television. The swing and tilt is adequate for my needs.

This is by far one of the best mounts on the market. The ability to move the mount the way it moves and the ease of installation as well

Looked around quite a bit online and finally went into the BestBuy store and a worker there showed me this mount. Super universal, it covers most sizes and with so many holes in the bracket you can be sure to line up your TV evenly on any wall. The TV pulls out and turns to each side as well as left and right to get that perfect center. Great choice and great value