A:AnswerThis appears to be a Mesh Router system with 2 nodes, either of which can be used as the main incoming router, the other is a wireless node used to either spread the signal from the main router or back feed a wireless signal to the main router. an extender only works one way just extends the signal. I have pretty much the same system and it works out to cover at least cover 5000 sq ft, which covers everything we use wirelessly. or Voip .
A:AnswerHi! While we have not tested all internet service providers, our routers work well with Fiber, Cable, Satellite, and DSL connections, compatible with most ISPs and modems that use Ethernet. Certainly, you can replace your existing router with the Atlas 6.
A:AnswerHi. Once the nodes are properly setup, you can connect the nodes using CAT5 or higher-rated ethernet cables and the nodes should automatically switch to a wired connection. You might find this link helpful: https://www.linksys.com/support-article?articleNum=217442.
A:AnswerYes, Juancho, you can utilize parental controls to restrict internet access during specific times. Here's a helpful reference: https://www.linksys.com/support-article?articleNum=140978
A:AnswerHi there. The child nodes can communicate with each other and pass the signal along the chain back to the main (parent) node. If the parent node is centrally located, it might reduce the number of hops and improve overall network performance.
A:AnswerYes, Carlos. The Linksys MX2000 is compatible with your Velop WHW03. To optimize performance, we suggest using the node with the better specifications as the parent node. Additionally, all the models listed at this link are compatible with your Velop nodes: https://store.linksys.com/support-article?articleNum=48323
A:AnswerHi, Carthur. You can use both Linksys nodes, setting one as the parent node and the other as the child node. You can also use it if you have two different networks or other modem and configured the two nodes separately as the main node.
A:AnswerFirmeware is probably out of date. Connect via the direct IP and manually prompt the download. Call customer service. I had similar issue day-1 install. 2-hrs w/ customer service to munually configure and update firmware
