Questions & Answers

Q: QuestionI have four definitive speakers with build in subs. I want to just use the speakers and unplug the subs. Will the speakers work with a separate Sub?

Asked 5 years ago by Rich.

• A:Answer Speaking about the tower speakers w/subs then yes, just use the high level inputs (ie the black and red terminals). Unplug the sub wire (LFE) and power cord you dont need it, since its for the sub amp. This is what I did with my bp8040-st's.

  Answered 5 years ago by Carminus

  Helpful (3)Unhelpful (1)ReportAnswer this questionShow more answers (1)

Q: QuestionI need to order the fuse and the part that holds it in place. Can I order it from the Geek Squad?

Asked 8 years ago by Anonymous.

• A:Answer Call DefTech and they can send you one.

  Answered 6 years ago by PETTYOFFICER117Verified Purchase

  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (4)

Q: QuestionIs the Supercube bluetooth

Asked 3 years ago by Sonnyo65.

• A:Answer Hello, the Subwoofer is not Bluetooth and must be connected using a hardline. However, after market wireless subwoofer kits are available.

  Answered 3 years ago by Definitivetech Team

  Helpful (1)Unhelpful (0)ReportAnswer this question

Q: QuestionI have Edifer R1850DB bookshelf speakers. I would like to add the SC 2000 Supercube just not sure if the 3.5mm out of Edifer can go direct single RCA to the LFE input on cube?

Asked 3 years ago by Kdawg.

• A:Answer Yes as long as the Edifer R1850DB is sending out a filtered bass signal. Connect a 3.5mm from sub out on Edifer speakers to RCA LFE subwoofer input. You will need a 3.5mm to RCA cable. The Super Cube does not have a low pass filter (cross over built in). Please consider our new Subwoofer line up. The DN10 or DN8. Both now have a low pass filter allowing you to fine to the crossover point.

  Answered 3 years ago by Definitivetech Team

  Helpful (1)Unhelpful (0)ReportAnswer this question

Q: Questionwhat is the warranty on the subwoofer? I have a blown speaker for sure

Asked 2 years ago by fhoward.

Q: Questionhow can I connect the subwoofer to my Denon AVR-S960H 8K AV receiver and to my rear speaks (see rear speak input in the attached image..)

Asked 4 years ago by yasin.

• A:Answer See page 8 of the manual https://s3-us-west-2.amazonaws.com/assets.soundunited.com/definitive/product_documents_legacy/SC%202000%20Manual_12.21.10_web.pdf?mtime=20161003165515 Your wall jacks show a single RCA jack on what I assume is the connection block for the rear speakers. What I can't see is if this is on the wall your speakers are to be located or if this is in the closet your receiver is in. If on the wall connect a standard RCA cable from the RCA jack on wall (top right) to the LFE input of the SuperCube 2000 and then on the other end, where the receiver is located, connect the RCA jack to your sub output on your denon with a standard RCA cable. For better performance upgrade your RCA cables to higher quality cables specific for subs.

  Answered 4 years ago by CJGAVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: Questionmy powerfield supercube 3 stop working when tested with speakers. getting power to the speaker is it possible to have a blown fuse?

Asked 4 years ago by GTO.

• A:Answer make sure the lfe out cord is in there correctly if it wiggles a little bit the sound shuts off I thought it had a bigger problem but that's all it was was just a cable end was loose it could be the fuse,I have the super cube 2 and on the back it has a fuse, there a slot for a small flat head screwdriver, just about a half turn then use your hand to take it the rest of the way out. If that's the problem you should be able to get it at a radio shack type store or a music store just make sure you get the correct one, when you take the fuse out it should have the info on there.

  Answered 4 years ago by Petey

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionWhere can I get a snap-on grill for the Supercube 4000 to protect the front speaker?

Asked 4 years ago by Donnie.

• A:Answer None available as far as I know.

  Answered 4 years ago by GreatVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionI have a pair of Beolab 18's and I'm looking for a less expensive alternative than the B & O sub (4,000) Does anyone know if this product would pair well with the B & O's.

Asked 5 years ago by Sebastian55.

Q: QuestionCan I use the 2000subwoofer with a 1000 system

Asked 5 years ago by Anonymous.

• A:Answer YES YOU CAN THATS WHAT I HAVE CURRENTLY

  Answered 5 years ago by BuckeyeVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (3)

Q: QuestionIs there a problem with the fuse blowing in these subwoofers?

Asked 5 years ago by Stew.

• A:Answer This sub is recommended to be plugged directly into a regular outlet. I bought a heavy duty extension cord and have mine plugged into an appliance power strip conditioner. No fuse issues whatsoever. If you're blowing fuses you're either pushing it hard or the voltage is off.

  Answered 5 years ago by DuggiefreshVerified Purchase

  Helpful (1)Unhelpful (1)ReportAnswer this questionShow more answers (4)

Q: QuestionIs the Super Cube subwoofer compatible with a Sonos sound bar?

Asked 5 years ago by JimmyV.

• A:Answer It is not, the Sonos soundbar does not have an LFE/Sub out which you would need to get signal to this unit. They make a wireless Sonos Sub that pairs with the soundbar.

  Answered 5 years ago by Ryan

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionCan I order it for European voltage 230v?

Asked 7 years ago by Anonymous.

• A:Answer I live in Sydney. I moved my entire US Surround sound system (Pioneer Elite) with definitive woofers and speakers over here. Attached to step down converter. Everything works well. Make sure you get one with sufficient wattage.

  Answered 6 years ago by Edward

  Helpful (1)Unhelpful (1)ReportAnswer this questionShow more answers (1)