A:AnswerNo. This unit has the ultra fresh vent. With the door closed, you can push the ultra fresh button to run the cycle. It essentially draws in fresh air, spins the tub, and dries itself out. Doesn’t use too much power and takes 6 hours to complete the cycle.
A:AnswerI had GE service out here once for an odd smell. Smelled like a weird chemical or something… they said it was drywall dust from renovations we had going on. It was getting into our dryer and burning. It’s definitely one of their more common calls. But if it smells like natural gas then you could have a leak and should call a plumber. My smell didn’t smell like natural gas, it smelled more like a strong chemical or burning plastics type smell.
A:AnswerIf you need to buy a new one, scan the QR code on the inside lip of your dryer door. It will take you to the GE parts catalog for your dryer. Parts are reasonably priced.
Idk what your warranty cover but definitely that would be a good option if you can swing it.
A:AnswerYou can only stack washer and dryers from the same model group.Every few years the dimensions change and are not compatible from older to newer. Unless you are VERY handy and can adapt a stack kit from a new unit,but almost impossible.
A:AnswerAll dryers come natural gas you would need an LP conversion kit for propane. whoever you buy it from should be able to tell you the cost but if you have never done one before DON'T attempt it! You need to dissasemble most of the dryer to do this and sometimes special tools are needed. Pay to have it done if needed.Gas is not to be fooled with.
A:AnswerFor a small load use the #2 line on the detergent cup cap,med to large loads go above #3.Detergent is ver concentrated now and don't worry if you don't see suds.Any size load is fine as the machine has a way to "weigh" the load to determine how much water it needs.Smart Washer.
A:AnswerYes.most have what is called a button trap at the bottom front of the washer.Some have a small door to open then a twist cap attached to a tray that catches things before they get into the pump.Some are accessed by removing the front panel to the machine.
