1-3 of 3 Answers
setup a wireless network, connect it and done. Your computer will find it automatically.
Sorry, there was a problem. Please try again later.You have to go to the printer settings page, that directs you to a webpage based status settings. From here you can make adjustments. But your printer must be connected to your network and internet if printing directly to it from an outside source.
Sorry, there was a problem. Please try again later.Hello, I would like to be able to answer this question for you. There are a few steps that you will need to take to set this model HP Wireless printer up for AirPrint. AirPrint on the HP Laerjet P1102w requires connection to the wireless network and a DHCP server as prerequisites. To join the wireless network you have to install the printer onto a Windows computer via USB and use the installed "HP Wireless Configuration" utility. A. First flash the firmware on the printer: 1. Turn the printer off 2. Holding down the "wifi" and "cancel" buttons while turning the printer on 3. Keep the "wifi" and "cancel" buttons held down for 15 secs then release This will rest the IP address of the printer B. Next, run the "HP Wireless Configuration" utility from the USB attached Windows workstation. This software is located on the start bar under programs --> HP --> HP Laserjet Professional P1100 Series --> Wireless Configuration. 1. Click "next" until you get to the "Wireless Discover Method" screen 2. Choose the "Advanced" radio button and then click "next" 3. Choose the wireless SSID that you would like to connect the printer to then click "next" ** Note: The wireless SSID can not contain spaces in the name as this will cause the connection to fail. These is no solution to this except to change the name of the SSID to a single word. This is a bug in the current version of the "HP Wireless Configuration" utility. 4. When prompted choose the encryption method for the wireless network and enter the wireless password then click "next". This will install a special driver for the wireless connection to the printer, attach the printer to the wireless network as a network printer using a DHCP address and print a test page over the wireless network. C. Once the printer has joined the wireless network the IP address can be obtained by holding down the cancel button until a configuration page is output from the printer. D. From a Windows workstation attached to the same wireless network browse to the web interface for the wireless printer and change the configurations to suite your needs. 1. From a web browser go to http://[IP Address of Printer from Configuration Page] 2. Click on the "Networking" tab in the web interface. 3. Click on the "IPv4 Configuration" link 4. Set the Host Name and IP Address information as you desire 5. Next, click on the "Bonjour" link 6. Set the "Bonjour Name" for the Printer name. ** Note: The Bonjour name is the name that iOS users will see when selecting the printer from their devices. 7. To print from the Windows workstation wirelessly, change the TCP port for the wireless printer driver to the IP address currently set for the wireless printer. Or delete this drive if you plan to always printing via USB from the Windows workstation.
Sorry, there was a problem. Please try again later.