1-3 of 3 Answers
Take the back off it snaps on the inside of that
Sorry, there was a problem. Please try again later.To clean the filters on the air conditioner: First unplug the cord and hold it up out of the way of the vented back panel by draping it over the top or taping it out of the way; Remove the exhaust hose by rotating the ring where it attaches to the back of the machine to provide clearance; On either side of the vented back panel, at the top, there are two tabs - pull back gently on these tabs and when the panel releases, tilt it back beyond the plane of it's recess and lift out exposing the interior; On both sides you will see two tabs, gently pull out the panels straight back and out; Wipe down all three items and gently vacuum from the outside - vent side in the reverse direction of air flow to remove the dust from the fine screens. Installation is the reverse: Slide the two side panels into their recesses; Insert the bottom of the large, screened back panel into the lower portion of the recess so that the studs engage their recesses then tilt the upper portion into the machine until it snaps in place. Reinstall the hose and plug in; one warning - the filtering screens are very fine and fragile so be careful while cleaning them and make sure to remove as much as you can or better, all of the dust if you decide to wash them to prevent "caking" of the dust. It's easier than it sounds - good luck!
Sorry, there was a problem. Please try again later.Super easy. The lower back pulls off and there is a filter in the piece that comes off which you can pull out and clean then in the unit where you removed the piece there is a filter on each side which slides right out.
Sorry, there was a problem. Please try again later.