“Connecting the sub My receiver has a single RCA sub pre out. This sub has left and right ins. What's the best way to connect to my receiver?”
Answer This Question
1-10 of 10 Answers
You can use L/R connections on very high end receivers but for a normal hookup you can use the single "L/LFE" line in hooked to the sub output on receiver.
Sorry, there was a problem. Please try again later.Use the white port on the sub, subs are mono so one line is all you require
Sorry, there was a problem. Please try again later.on the sub itself the top RCA input is for the single RCA, the left and right is for an older reciver that does not have a dedicated sub out
Sorry, there was a problem. Please try again later.There is more information in the manual; however, one output on the receiver should go to the single, Left input that is labeled LFE. I've done this with my Yamaha receiver and it has nothing short of exceptional sound.
Sorry, there was a problem. Please try again later.The lfe channel on the sub, which I believe may be the left? It will say lfe on the back.
Sorry, there was a problem. Please try again later.buy a quality y cable that's shielded like the subwoofer cable connect the y cable to the left and right in on the sub other end to the subwoofer cable
Sorry, there was a problem. Please try again later.Get an adaptor that will allow you to plug into both the right and the left ports. Ask any of the employees in the audio department and i'm sure they will hook you up.
Sorry, there was a problem. Please try again later.Use the RCA jack and just connect it to the L/LFE on the AMP.
Sorry, there was a problem. Please try again later.For most setups, you would hook it into the left in on the sub.
Sorry, there was a problem. Please try again later.I did mine the same way. It just plugs into one side. I think it's left but can't remember off hand.
Sorry, there was a problem. Please try again later.