“How easy is it to level this washer? We have an uneven laundry room floor & even when leveled (often not easy) previous washers have required us to actually sit on the washer to keep it from jumping around. Is this washer easy to level and keep leveled?”
Answer This Question
1-6 of 6 Answers
We paid the small fee to have the delivery men install both the washer and dryer for us, so the levelling was done for us by professionals. It too them no time to handle this task, as opposed to how long it may have taken us. I would recommend letting the professionals do it next time.
Sorry, there was a problem. Please try again later.I have tile in my laundry room and it has adjusters for it to make it level
Sorry, there was a problem. Please try again later.Haven't had an issue the installers adjusted the legs and The tub actually pre spins the load to adjust for balance and amount of water to use
Sorry, there was a problem. Please try again later.Very Easy. My floor is level but I did use a level when I put it in place and adjusted the feet as needed, the unit was easy to level and has stayed that way for the month I have owned it. No unbalanced loads to date.
Sorry, there was a problem. Please try again later.This washer set on any ground level and also auto level from set up control so. Nothing to worry about it level itself before start to work.
Sorry, there was a problem. Please try again later.Hello Baka, Leveling the LG - 4.5 Cu. Ft. 8-Cycle Ultra-large Capacity High-Efficiency Top-Loading Washer, Model # WT1201CV is not a complicated procedure at all and can be accomplished quite easily. Turning the leveling feet clockwise will raise the washing machine and turning counter-clockwise will lower it. The leveling feet should only be adjusted only as far necessary to level the washer, extending them more than necessary will cause the machine to vibrate. Leveling feet that move or slide on the floor can contribute to excessive vibration or noise due to poor contact with the floor! The washing machine spins at very high speeds up to 1,100 RPM and this could cause bodily harm or damage the washer, your laundry, or your property! Obviously, the biggest concern here is that of the unevenness of your floor, it sounds extreme if by your own admission, you have had to sit on other machines to keep them from jumping around! I would strongly advise that you have the floor leveled rather than take a chance and have to resort to such measures to keep the machine from jumping around! This machine will not be different in that regard from your previous washing machines! Leveling should be easy, and simple and without event!...IFV
Sorry, there was a problem. Please try again later.