A:AnswerYou can probably still mount it but the tray won't be able to rotate up level with the desk top if it is stopped by the bottom of the face board. If you could cut a notch the width of the arm which is about six inches, in the face board (level with the bottom of the desk), then that would most likely work.
A:AnswerDimensions: 4” (W) x 10” (D)”
Tilt: 15°
Swivel: 20°
Slide: 12.6”
PLEASE NOTE, THIS KEYBOARD TRAY HAS A TRACK THAT MEASURES 7 IN WIDE AND 18.2 IN LONG. PLEASE ENSURE YOUR DESK HAS ADEQUATE SPACE FOR THE TRACK TO CONNECT TO.
A:AnswerIt slides straight back. In raised position the bottom is about 3.5” below the mounting surface. Mine pushes in just behind the front edge of the desk. You could probably adjust the track installation to get another inch or two but not much more than that.
A:AnswerHi Bob, The dimensions of the keyboard tray on this model are 10" x 26.38". It looks like the dimensions on your Logitech K350 keyboard are Height: 10.4" (26.51 cm) and
Width: 19.69" (50 cm) so this keyboard tray may be a bit too small for your keyboard.
A:Answer1", biggest challenge is, fore, and aft spacing between lower surface desk boundaries. I had to route out approximately 1/4" each side to accommodate base flush-ness mount.
A:AnswerIt depends on the dimensions of your corner desk. The track that mounts under the desk is probably about 18 inches deep and 6 inches wide so would likely fit on even a small desk. The actual keyboard and mouse tray is pretty large at over 26.5 inches wide and 10 inches deep. Depending on your desk, the tray could be too large or may be limited in left/right movement. It also drops down several inches from the bottom of the desk so you’ll need to think about clearance for chair and knees.
A:AnswerI wouldn't recommend mounting it on a drawer. That would make it as low as the bottom of the drawer. I would guess that most drawer bottoms wouldn't be strong enough to hold the weight and the physical action of the cycling of the keyboard up and down.
A:AnswerDimensions: 4” (W) x 10” (D)”
Tilt: 15°
Swivel: 20°
Slide: 12.6”
PLEASE NOTE, THIS KEYBOARD TRAY HAS A TRACK THAT MEASURES 7 IN WIDE AND 18.2 IN LONG. PLEASE ENSURE YOUR DESK HAS ADEQUATE SPACE FOR THE TRACK TO CONNECT TO.
A:AnswerThe tray height can be adjusted to clear the desk edge. For me, when fully extended, the tray arm sits 3” below the underside of my desk, where the track is mounted. I don’t know about the screw length as my desk top is 1.5” thick.
