1-6 of 6 Answers
Hi Bill, The height of the NX58H9500WS can be adjusted between 36-3/16" and 37-3/16". Thanks for your interest, Ms. Samsung
Sorry, there was a problem. Please try again later.Hi Bill. Thank you for reaching out regarding your Samsung - 5.8 Cu. Ft. Self-Cleaning Slide-In Gas Convection Range leveling the legs. Regarding your concern, here are the steps. Level the range: 1. Make sure the range is positioned where you want it. 2. Using a wrench, level the range by turning the front leveling legs in or out as necessary. Counterclockwise shortens the leg and lowers the range. Clockwise lengthens the leg and raises the range. NOTE • Adjusting the two front legs is usually sufficient, but all four legs adjust if necessary. • Adjust the leveling legs only as far as necessary to level the range. Extending the leveling legs more than necessary or removing legs can cause the range to be unstable. 3. If range is next to or between cabinets, make sure the cooktop (without the surface burner grates) is level with the countertops. 4. Position an oven rack in the center rack position. 5. Check the level of the range with a carpenter level using the two positions shown at right. 6. After the range becomes level, slide the range away from the wall so that the anti-tip bracket can be installed Here is the link to your installation manual for further assistance. Please go to page 27. https://downloadcenter.samsung.com/content/EM/201903/20190314213235246/Install_NX58H9500WS_DG68-00555A-09_EN-MES-CFR__WEB.pdf Should you need more assistance, please feel free to get back to us via the following options: 1. Facebook Messenger: http://m.me/samsungsupport 2. Twitter: https://twitter.com/messages/compose?recipient_id=18768513 3. Samsung Community: https://us.community.samsung.com/t5/Samsung-Community/ct-p/us Thank you for being a valued customer of Samsung. Have a great day. Reference Ticket Number: 1144278241 ^Camille
Sorry, there was a problem. Please try again later.Yes, but as with all leveling legs, they have limitations. If you want to be safe, slide it in on a piece of half inch plywood. That should also help protect your floor a bit.
Sorry, there was a problem. Please try again later.Do not put shims under the legs in the back, because they will not lock into the anti-tipping device on the floor
Sorry, there was a problem. Please try again later.Yes, it has adjusting feet.
Sorry, there was a problem. Please try again later.Yes, you can raise is about 1 inch. if that isn't enough, you can put shims under the feet.
Sorry, there was a problem. Please try again later.