1-3 of 3 Answers
This worked for me. Thank you to the person who posted. SOLUTION: To ensure ease of re-pairing, please unpair or forget your SESH® EVO in your paired Bluetooth device list Remove the SESH® EVO from the charging case and Manually Power OFF: Touch and hold BOTH buds for 6 seconds Once both buds have been powered OFF: Touch and hold each bud for 10 seconds to completely reset them (this will power cycle them on and off again). Once both buds have gone through the power cycle: Place the buds back in the case until both LED’s show red, and then pull them back out. Both buds will automatically power ON and the LED’s will simultaneously flash BLUE while they sync to each other. Once the buds have synced together: You will hear a tone to indicate the sync was successful and ONLY the LEFT bud will begin to flash RED/BLUE.
Sorry, there was a problem. Please try again later.Thank you for your feedback! Please feel free to visit info.skullcandy.com for troubleshooting information for connectivity. If that doesn't remedy your issue, please reach out to us at contact.skullcandy.com and we can assist you in getting a new pair that functions properly.
Sorry, there was a problem. Please try again later.I checked out the pairing issues section (copied below) on your support page. However it looks like the two BUDs are not syncing with each other. At the step where it says that "BUDs would sync with each other, there is going to be a tone and only left bud would blink with red/white", the results I got was not as expected. For me, the right BUD started blinking red/blue and the left BUD is still blinking blue. PAIRING ISSUES? ISSUE: The biggest challenge with true wireless earbuds is ensuring your buds are properly connected to each other and your device. There are times when users will unintentionally disconnect the buds and change their paired state, this can create pairing challenges and impact your ability to use either bud solo (Master Role Switching). Do not worry, as this is an easy fix! SOLUTION: To ensure ease of re-pairing, please unpair or forget your SESH® EVO in your paired Bluetooth device list Remove the SESH® EVO from the charging case and Manually Power OFF: Touch and hold BOTH buds for 6 seconds Once both buds have been powered OFF: Touch and hold each bud for 10 seconds to completely reset them (this will power cycle them on and off again). Once both buds have gone through the power cycle: Place the buds back in the case until both LED’s show red, and then pull them back out. Both buds will automatically power ON and the LED’s will simultaneously flash BLUE while they sync to each other. Once the buds have synced together: You will hear a tone to indicate the sync was successful and ONLY the LEFT bud will begin to flash RED/BLUE.
Sorry, there was a problem. Please try again later.